Selection of Covers and Frames
Carson products are used in a wide range of locations. Covers are an integral part of a box system and we can advise on strength, materials and different styles.
- Strength: covers are available from A15 to Class E600 load strength
- Material: HDPE, Concrete Infill, Iron (Ductile [SG] or Cast [GG])
- Style: Covers can be HDPE with lift up sections, insulation
Material & Process Description
Structural Foam Moulding, using HDPE and nitrogen to create a honeycomb structure between the two exterior plastic skins. This process gives the following advantages:
- Low pressure gives stress free parts and reduces warpage
- Strong products that are easy to handle and install. No special lifting equipment required
- High stiffness to weight ratio
- Excellent impact resistance
- Non-pourous surface will not absorb moisture
- Excellent chemical resistance
- No CFC's are used in the process
- Easy to drill and cut for duct access etc
- Good thermal insulation
Application Instructions
As the leader in the field, our technical staff can provide application advice and installation instructions for your application.
|
| |
|
|
